Has anyone had trouble installing the Dynacorn version of the Door Sill plates?
I purchased a set from WCCC but it seems the holes are about a 1/4" off. I can force them on with the screws going in off center. I go back to my originals and no issues.
The problem with forcing them on is I have cracked the edge of my kick panel.
Thanks for any suggestions.
Kevin
The main problem I had with the Dynacorn ones (back in 2019 so I don’t know if they’ve been updated) was the cutouts on either side for the windlace and kick panel were too shallow, and didn’t allow them to sit down all the way. The Scott Drake ones were a little better in this regard, so that’s what I went with. I did think the Dynacorn ones were better looking, though. I have some comparison pictures in my build thread here: The Snowball Saga - '68 Standard Revitalization Project - #296 by Blitz