No clone or tribute in mind. This is just a driver quality base 67. PO had too tall air cleaner at one time and put some small dimples in hood. I recently installed a Holley Sniper Stealth with a 1/2 spacer and had minimal clearance myself. After a few spirited drives and seeing my brand new fan shroud destroyed, I knew the drivers side motor mount was gone. I only noticed after the MM repair that the hood damage was now worse. 
Older acrylic enamel paint would be near impossible to match and painting the whole car is out of the question. I was thinking repair the damage, paint a stripe on the power bulge and add a color matched scoop to make it all come together.
Will the Eliminator scoop fit the profile of the 67-68 hood?
Functionality isn’t really a concern. Not wanting to cut a hole in an otherwise good quality hood.
Thanks for the feedback.
Brian
